Donald Jasurda to Present to Composites Professionals at Midwest Event

TROY, Mich., April 8, 2011 -- Dimensional Control Systems, Inc. (DCS), provider of dimensional engineering software solutions and consulting services, today announced that Vice President Donald Jasurda will address aerospace and defense engineers and manufacturers at the Composites Manufacturing Conference. The event will be held at the in Dayton, Ohio, April 12 through 14. 

Jasurda's presentation is part of the Design & Software session that begins at 9:30 a.m. on April 13. He will focus on “Use of Simulation Based 3-D Tolerance Analysis.” Specifically, he will discuss how the correlation of theoretical tolerance analysis results produced during engineering simulation to actual as-built results can help manufacturers validate or adjust as-designed simulation parameters to more closely align with production process capabilities.

The Composites Manufacturing Conference brings together manufacturing engineers and management from aerospace, medical, wind energy, transportation, recreational, consumer products and green manufacturing to share cutting-edge knowledge on composite applications, processes and best practices.

"Composites manufacturers can shorten launch cycles, reduce rework and downtime, and improve process capabilities by using 3D tolerance analysis across their products’ lifecycles," said Jasurda. “I look forward to sharing with this group of industry leaders how dimensional engineering approaches can help them achieve these business goals.”

For more information about the Composites Manufacturing Conference, see http://www.sme.org/cgi-bin/get-evdoc.pl?&&002013&000007&april13&&&SME&
 

About Dimensional Control Systems

Dimensional Control Systems Inc. (DCS) is a world-class experienced provider of dimensional engineering software solutions and consulting services. Established in 1994, DCS is a privately held company with partners and customers around the world.  Leading organizations like Airbus, BMW, Boeing, Chrysler, Daimler AG, Embraer, General Motors, Herman Miller, IBM, Lockheed Martin, Volkswagen, and many major tier-one and tier-two suppliers use DCS solutions to optimize product design and manufacturing processes, improve quality, and reduce program cost and timing. DCS’ 3D tolerance analysis and quality assurance software applications fully support the entire product quality lifecycle. 

For more information, see www.3dcs.com.